AFTparts
Sprocket 3041916 || Caterpillar 279C, 289C, 299C, 299D, 299D2, 299D3
$344.00 CADUnit price /UnavailableVery low stock (5 units)AFTparts
Idler 3041878 || Caterpillar 259B3, 259D, 259D3, 279C, 289C, 299C
$670.00 CADUnit price /UnavailableLow stock (13 units)
Caterpillar 299D2 Undercarriage Parts: Sizes, Part Numbers and Care
AFTparts Canada lists front idlers and drive sprockets for the Caterpillar 299D2 on this page, each matched to the machine by its product page. Fitment lists often span several models, so match your own track stamp or part number before you order.
What fits
- Front idler — 3041878
- Sprocket — 3041916
How to confirm fit
- Step 1: Read the model and serial number on the machine plate (299D2).
- Step 2: Match the number cast or stamped on the roller, idler or sprocket, and count sprocket teeth and bolt holes.
- Step 3: Check the tread letter or part reference on the old part if you want the same pattern or design again.
- Step 4: Still unsure? Use Check Fitment on Contact Us with model, serial and part numbers.
Choosing between listed options
Each listing here covers a specific part number or track size. Where the stamp is unreadable, photos and measurements let our team compare the part before you order.
Reading a rubber track size
The size moulded inside a track gives width, pitch and link count. Treat any letter code as the tread pattern; the three numbers are what must match your machine.
Signs a part is due
- Tracks that slip or jump on the sprocket under load.
- Rollers that leak oil or no longer turn freely.
- Idler flanges worn thin on one side.
- Lugs cracked down to the cords.
Before you order
Write down the serial number, the track size and the part numbers you can read. If anything is worn away, take photos; that is usually enough to confirm a listing.
Inspection and Canadian conditions
- Check both tracks for chunking, cracks at the lug base and visible steel cord.
- Measure sag as the manual describes, and again once the machine warms up on a frosty morning.
- Look for rollers that do not turn, oil at the seals and idler flanges worn on one side.
- Look at sprocket teeth for sharpening or hooking.
After snow or mud work, clean the track frame before the machine sits in the cold. On rocky or demolition ground, avoid sharp counter-rotation turns.
Replace one part or several?
When one component is clearly worn, check the rest. Fitting a new track on a worn sprocket shortens its life; matched replacement usually gives more even wear.
Related guides and collections
See Caterpillar hub, idler wear and replacement guide, sprocket wear and replacement guide and Caterpillar rubber tracks guide.
FAQ
How do I pick the right sprocket?
Use the number on your current sprocket and count the teeth and bolt holes before ordering.
Do parts for related machines fit the Caterpillar 299D2?
Only when the product page lists your model. Check each listing and your part number.